Installed in the hopper of the measuring mixing device.
Easily solve powder bridges that cannot be resolved with knockers or vibrators!
Here is a case we received from a weighing device manufacturer. ■Consultation Details In equipment already delivered to the user, the moisture content of the raw material has become higher than initially expected, causing a bridge to form in the hopper of the weighing device. Is there a low-cost and simple way to address this? ■Response Upon reviewing the drawings and the raw material, we determined that the hopper discharge diameter was small at 50mm, and the flowability of the raw material was not particularly poor, so we concluded that only measures immediately above the discharge section were necessary. ■Result We received feedback that "it is working well with equipment costing only a few tens of thousands of yen." 【Overview】 Hopper Diameter: 600mm Discharge Diameter: 50mm Raw Material: Bulk density 0.6, size approximately 0.5mm, with some moisture Blow Disk Type: Mini Blow Disk Installation Position: Two units 75mm above the discharge section along the hopper surface, and two more units an additional 75mm above. Since blow disks are inexpensive, even if many are installed in a large hopper, the costs remain limited. We will actively inform you about the installation positions and operating methods. *For more details, please refer to the catalog or feel free to contact us.
- Company：ミナギ
- Price：Other
